The tote has a 3/4 " hole drilled in the center of one end and about 3" from the top of the tote. This is where the plumbing will penetrate the tote.
The inside and outside plumbing connect at this hole using threaded PVC NOT GLUED and O rings inside and out.
The outside plumbing turns 90 degrees down toward the floor. A few inches above the floor the plumbing turns another 90 degrees toward the front of the tote. Then I have a ball valve for drainage. At the end of this I have a connection for a water hose also to be used for drainage if needed.
This outside "arm" will swivel cos it's a threaded connection. I can tilt it back and up to drain into a container rather than using a water hose if so needed.
Thats the outside. The inside is coming up next. It's
Time!!!