Hello all!
I just set up an aerocloner. Here it is.
Square Bin.
3/4 in tubing
Elite 803 pump
8 inch bubble wand.
The tubing (8 pieces total in rows of 4), is approximately 4 inches long. Most of the length is above the level of the top of the bin, with perhaps a 1/2 in below. The tubes are set far apart enough. with no escapable holes besides the tubes.
My question is: How far into the bin should the stem extend, should the bubbling water be allowed to touch it. Should I even use rooting powder in this system? I just want to use this to clone. Also, do I need to put a humidity tent over the clones? So far, I have 4 ( all 6 inches and above)clones in the machine and 2 are starting to wilt, 2 are staying the same. I cannot say for certain, what the difference I did to them are. Some are touching the water , some aren't, but it doesn't figure what is causing them to wilt.
Anyone with experience please help. |