Delta9420's DIY $30 Bubble Cloner - Page 2

Delta · 01-04-2002, 01:24 AM

... under Construction. I dunno, but here we go!

Attach the bubble wands to the bottom of the stackable shelf with zip ties or some other INERT material that wont rust (Tape?).

Stem wire wouldn't be a good idea down here because it'll rust and these will be submerged in a solution, constantly.

Delta · 01-04-2002, 01:26 AM

And, clean up the loose ends.

Also, you can see in this pic where I bent the legs of the shelf inward until I got it to fit just right inside the rubbermaid. About 45 degrees is what it took.

Delta · 01-04-2002, 01:29 AM

in the platic sheild that came with the light.

On both sides, but not the bottom. The idea here is that by submerging the cutting in only 1/4-1/2 inch of solution it produces quicker results than putting it in too deep. Plus, it's always a pain to get all the clones cut perfectly the same length.

We will use these as the stem cups. If you can figure out something else easier, just make sure it's inert. This will ultimately be submerged, also.

Just wait, you'll see ...

Delta · 01-04-2002, 01:34 AM

So, I'm going to use stem wire to attach the cups in these pics. I'd still recommend zip ties because they are plastic. But, I'm not going to the store for this one. Use your imagination.

Delta · 01-04-2002, 01:36 AM

After drilling the holes in the plastic shield that came with the light, cut it up into 1 1/2 inch sections to attach to the bottom of the shelf.

Look at this ...

Delta · 01-04-2002, 01:38 AM

to see how it fits.

Delta · 01-04-2002, 01:44 AM

To fit over the stackable shelf. You want to completely cover the top with enough left over to wrap it under and tape it down.

'95 jnco's ...

Delta · 01-04-2002, 01:46 AM

Here's what mine ended up like, looking at it from the bottom.

Delta · 01-04-2002, 02:08 AM

In the bag. I placed the CDs on the shelf to mark what spaces to cut so when its completed it can hold a total of 12 water clones.

You can also see that the holes are cut directly above the cups. This is for you to drop the cutting in. The cups will hold them at exactly the right level in the water.

Delta · 01-04-2002, 02:13 AM

... this is what we have so far.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY Bubble Cloner - come bubble with the Freak	Freakshow68	Propagation	86	07-31-2009 03:34 PM
Bubble cloner questions	tripps	Propagation	14	12-10-2008 12:52 PM
Delta9420's DIY $30 Bubble Cloner	Delta	Propagation	48	08-10-2008 06:50 AM
DIY Bubble Cloner - come bubble with the Freak	Freakshow68	Cloning & Propagation	43	03-13-2008 02:15 PM

New To Site?	Need Help?
Register to Participate View Forum Leaders Privacy Statement Contact Us	Frequently Asked Questions Did you forget your password? Mark Forums Read

Hot Products: