Zait

My clones exhibit similar symptoms as this poster's and I've been using the no wilt stuff (by spray). My clones are in a dome in rockwool though. I'm going to try some without it.

__________________
Happening NOW: Zait's Indoor Productions Presents Hempy Blueberry

Pics of my first outdoor harvest

$now

I put 13 new clones in. pH 6.4, 150ppm, 69-74 water temp. plants started to exhibit the same symptoms as before at day 3. Curling leaves, black spots on tips of leaves and inner fan leaves. I put a humidifier in the room and it fluctuates between 50%-80%. That's what my $10 Walmart humidity meter tells me.
Can I have to much humidity when cloning?
Since the same defects are reappearing on top of the clones and not the bottom I decided to get a humidity dome. I took fresh clones and the 13 from before and put them under the domes. Sleeping with my fingers crossed at this point.
Anyone else have their ?

4th pic is the new baby girls

PUffin tuFF

Attached Thumbnails

     

 

Coughee

I run an EZ also and temps are crucial in getting good roots. I run 70 - 74 degrees with a lil bloom nutes and some Propogaor, ppms around 275. I then set the ph to 6.0 flat. The ph seems to slowly rise and the 6.0 to 6.3 rnge seems to keep the leaves very green for a long time. I've had hard strains to root that still looked lush green in 28 days. I also like a rez change every week. I use a clear bin as a dome, I only use the dome for the first 3 or 4 days. You have to introduce them slowly, leaving the lid off for more time each day until they can stand on their own. When I do this the clones seem to catch in their medium quicker with less stress to the plant.